| At first I cut a shelf board to the depth that a gun can be about to raise. A chip of wood is in four sides and central neighborhood to a shelf board. Because I tend to become hollow in a shelf board, I saw a chip of wood after at first having cut a board with a cutter knife. In this situation because I see a cavity, I put a chip of wood. When a gap is open between a shelf and the back of a rack, the one that buried a gap in chip of woods is stable. However, a gap is open this time, but does not seem to move with heaviness of a gun even if there is not it. I stuck a cushion with glue without putting a chip of wood by corner-cutting construction this time. |
 |
| I can make holding the barrel favorite height by changing a position of a screw. |  |
| I put a collection afterward, and it is completion. I think whether I may use wood-tone tape. (This has done a slipshod job, too.) Because it was not high, the rack which I used this time was in only a thing of length of SMG degree. Please use it after confirming that there is height of an entering thing. There is a gap behind holding the barrel. However, it does not move with weight of a gun for the moment. I did not dig a ditch this time. However, if there is some weight, a gun does not seem to work. (Because I was light, M31 has turned.) |
 |